Modern-ag 10' Offset Flex Predator Instrukcja Użytkownika Pobierz pdf (Strona 34)

100

101



OPERATION SECTION



 

  

 

 

 

in this position.

 

PTO shaft.

 

 

 

opposite section. Cut this length off with

a saw.

 

 

driveline.

 

Engagement Check Procedure

 

 

 

 

 

 

 





NOTE: If the driveline cannot be shortened and still maintain the required prole engagement, the operator must

be made aware of terrain conditions and avoid situations which pose a potential problem to avoid damaging

the driveline.

OPERATION

FL15M 02/07 Operation Section 4-17

OPERATION

Shorten the driveline profiles as follows:

• Remove the driveline from the tractor.

• Position the mower to the point with the short-

est distance between the tractor PTO shaft and

cutter gearbox. Shut down the tractor and

securely block the mower in this position.

• Pull driveline apart and reattach yoke to PTO

shaft.

• Hold driveline sections parallel to one another

and measure back 1” from yoke of each shaft

and place mark on opposite section. Cut this

length off with a saw.

• Round off all sharp edges and debur.

• Thoroughly grease then reinstall the driveline.

• Recheck for proper operation.

Engagement Check Procedure

• With the driveline attached, position the mower to the point where the telescoping driveline is at its maxi-

mum extension. Completely shut down the tractor and secure in position.

• Mark the inner driveline shield 1/8” from the end of the outer shield.

• Disconnect the driveline from the tractor and separate the two driveline halves.

• Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline

profiles were engaged.

• If the engaged length is less than 12” for a CV driveline and less than 6” for a non-CV driveline, the shaft is

considered too short and should be replaced with a longer shaft. Consult an authorized dealer to pur-

chase the required driveline length.

NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the operato

must be made aware of terrain conditions and avoid situations which pose a potential problem to avoi

damaging the driveline. OPS-R-0005

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 100 101

Komentarze do niniejszej Instrukcji

Brak uwag

Modern-ag 10' Offset Flex Predator Instrukcja Użytkownika Strona 34

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Modern-ag 10' Offset Flex Predator